No products

Shipping $0.00
Total $0.00

Cart Check out




1mm 1trk magnetic head

1mm 1trk magnetic head1mm 1trk magnetic head
Move your mouse over image or click to enlarge
1mm 1trk magnetic head 1mm 1trk magnetic head 1mm 1trk magnetic head sizes

***OUT OF STOCK*** 1mm 1trk Magnetic Head

Size: 1.1mm / 4.8mm / 7.7mm 

More details

1mm 1trk magnetic head



This head was designed to work BEST with the MCR-EVO.


Get it cheaper in our MCR-EVO Complete KitMCR-EVO Combo




1mm 1trk head sizes

1.1mm - THIN       4.8mm - WIDTH      7.7mm - LENGTH


Note: Because of the protection layer applied over the coil, the thickness can vary with + 0.1mm


1mm 1trk head perspective


280  OHM


1mm 1trk head side

Magnetic Head Full Specifications:


Inductance mH 55
DC Resitance Ohm 280
Recording Density BPI 210
Tape Speed IPS 7.5
Read Output mVp-p 15min
Insulation Mohm 20(100v DC)
Track Width mm


This 1 track magnetic head, when used with any of our magnetic card readers, can record the data on the magstripe card when the card reading swiping is made. If the card reading swipe was interrupted, recovering the data on the magstripe tracks depends entirely of the magnetic stripe card reader and NOT of the magnetic head.

The magnetic head only records the signal provided by the magstripe on the card and transmits the data to the magnetic card reader.

In this case, this head can read only one track from the magstripe card. The tracks that can be read from the magstripe depends of the position of the head. It can read the track 1, track2 or track 3 depending how it is placed.

Please note that the magnetic head if sold separately or within a combo deal will not come with any rail that the card reading swipe can be made on, so the rail it's the client responsability.

Click here to see an example of how to place the 1mm magnetic head

Warranty information

This product is guaranteed to be free from defects in materials and workmanship for 30 days since the date of purchase. will without charge, repair or replace at our option, any product returned for warranty work and found to be defective by us.

VERY Important!!! Please note that we test every magnetic head before being sold and we make sure that they are in perferct working condition. Even though we have tried to protect it as much as possible by applying a protection layer over it, it is still a 1mm thin magnetic head, so please be very careful not to break the connection pads when soldering the wires on it. After that encapsulate it in a hard epoxy to make sure the connection pads won't break. will NOT replace any products if damaged by the client!